Instruction Manual

8
Insert the rudder end by pressing it up on the tube at the
end of the steering system, while holding the upper side
of this tube with the other hand’s forefinger to balance
the force. Spread the spring ends if necessary, they
must stay outside of the rudder end.
INSTRUCTIONS OF USE
MANUFACTURER NOTES:
* Never try to move the wings up/down manually!
* This product was tested for a lifespan of hundreds of
cycles in flight; however, it remains a high technology
product that should be handled with care when not
flying. Avoid seizing it by the wings or tail, place it
carefully and gently on the charging slot, proceed gently
also when replacing wings.
I - INSTALLING BATTERIES IN THE
TRANSMITTER
Please install 4 AA/LR6 1,5V batteries at the back of the
transmitter (open the battery cap by unscrewing it).
Warning: ensure that the + and - polarities match the
illustrations inside the battery compartment.
II – TRANSMITTER FUNCTIONS
Left stick - Throttle control: this stick controls the power
of the flapping of the wings and therefore the speed at
which MetaFly gains altitude.
Right stick - Direction stick: push briefly left or right.
Avoid oversteering.
Automatic power-off function:
If not in use for l0 min, the transmitter will turn itself off