User's Manual

Clamp

To cut the keys properly, Anycut needs a clamp to hold the keys

and key blanks tight. The picture below shows the 5-side clamp

that is fitted with the Anycut key cutting machine.

① Markers: Align the keys to the markers to hold the key in place.

② Tightness Adjustment Screw: Use a hex wrench to adjust the

tightness of the clamp. The tighter the screws, the harder the

clamp rotates and change sides.

③ E-Side Key Fixator: Tighten the screw on the top to fix the key

on E-Side clamp in place.

④ Limit Marker: Shows the limit of the right side of the clamp.

 Do not move the right slider too far away from the marker.

⑤ Knob: Used to move the right side of the clamp to fix(or unfix)

the key.

①

②

③

④

⑤