User's Manual
Table Of Contents
- TRADEMARKS
- COPYRIGHT
- DECLARATION
- OPERATION INSTRUCTIONS
- CAUTIONS!
- AFTERSALES-SERVICES
- 1GENERAL INTRODUCTION
- 2GETTING STARTED
- 3UPDATE
- 4DIAGNOSIS
- 5SPECIAL FUNCTIONS
- KEY PROGRAMMING
- EEPROM ADAPTER
- EPB RESET
- OIL LIGHT RESET
- SAS RESET
- TPS MATCH
- INJECTOR CODING
- ABS BLEEDING
- GEARBOX MATCH
- GEAR LEARNING
- SRS RESET
- DPF REGENERATION
- BMS MATCH
- AIR SUSPENSION
- CYLINDER
- TPMS RESET
- TYRE REFIT
- HEAD ADJUSTMENT
- WINDOWS INITIALIZATION
- SEAT MATCH
- ELECTRONIC PUMP ACTIVATION
- TRANSPORT MODE
- DIY MODE
- ODO RESET
- 6SETTINGS
- 7REPORT
- 8REMOTE ASSISTANCE
24
vehicle, and the main test line should be connected to the OBDII-
16 adapter and the tablet
The connection method is shown in the figure below:
Fig 4-1
1
Tablet
2
Main Test Cable
3 OBDII-16 Connector
4
Vehicle
*Caution: Please make sure all the cables are connected tightly;
The vehicle’s DLC is not always located under the dash; for the
location of the DLC, please refer to the vehicle’s user manual.
DIAGNOSIS
After the tablet device is properly connected to the vehicle, you
could start the vehicle diagnosis.