User's Manual
Table Of Contents
- TRADEMARKS
- COPYRIGHT
- DECLARATION
- OPERATION INSTRUCTIONS
- CAUTIONS!
- AFTERSALES-SERVICES
- 1GENERAL INTRODUCTION
- 2GETTING STARTED
- 3UPDATE
- 4DIAGNOSIS
- 5SPECIAL FUNCTIONS
- KEY PROGRAMMING
- EEPROM ADAPTER
- EPB RESET
- OIL LIGHT RESET
- SAS RESET
- TPS MATCH
- INJECTOR CODING
- ABS BLEEDING
- GEARBOX MATCH
- GEAR LEARNING
- SRS RESET
- DPF REGENERATION
- BMS MATCH
- AIR SUSPENSION
- CYLINDER
- TPMS RESET
- TYRE REFIT
- HEAD ADJUSTMENT
- WINDOWS INITIALIZATION
- SEAT MATCH
- ELECTRONIC PUMP ACTIVATION
- TRANSPORT MODE
- DIY MODE
- ODO RESET
- 6SETTINGS
- 7REPORT
- 8REMOTE ASSISTANCE
48
The shock absorber is not the same height due to air leakage,
maintenance, replacement, etc.;
After replacing the air pump assembly;
After replacing the control tablet ECU.
CYLINDER
This function is suitable for power balance after replacing and
repairing the cylinder.
TPMS RESET
Tire Pressure Monitor System (TPMS) Reset allows you to quickly
look up the tire sensor IDs from the vehicle ECU, as well as to
perform TPMS replacement and reset procedures after tire
sensors are replaced.
This function allows you to quickly look up the tire sensor IDs from
the vehicle’s ECU, as well as to perform TPMS replacement and
sensor test.
After the tire pressure MIL turns on and maintenance is
performed, the tire pressure resetting function must be
performed to reset tire pressure and turn off the tire pressure
MIL.
Tire pressure resetting must be performed after maintenance is
performed in the following cases: tire pressure is too low, tire
leaks, tire pressure monitoring device is replaced or installed,