Certifications 2

Material Safety Data Sheet
Report No: ZKS201100655-1 Page 5 of 9
sand or earth). Scoop contaminated absorbent into an
acceptable waste container. Collect all contaminated
absorbent and dispose of according to directions in
Section 13. Scrub the area with detergent and water;
collect all contaminated wash water for proper
disposal.
Section 7 – Handling and Storage
Handling
Do not dismantle, open or shred secondary Power
Bank;
Don’t handling Power Bank with metalwork. Do not
open, dissemble, crush or burn battery. Ensure good
ventilation/ exhaustion at the workplace.
Prevent formation of dust.
Information about protection against explosions and
fires: Keep ignition sources away- Do not smoke.
Storage
If the Power Bank is subject to storage for such a
long term as more than 3 months, it is recommended
to recharge the Power Bank periodically.
3 months: -10℃~+40℃, 45 to 85%RH
And recommended at 0℃~+35℃ for long period
storage.
The capacity recovery rate in the delivery state
(50% capacity of fully charged) after storage is
assumed to be 80% or more.
Do not storage Power Bank haphazardly in a box or
drawer where they may short-circuit each other or be
short-circuited by other metal objects.
Keep out of reach of children.
Do not expose Power Bank to heat or fire. Avoid
storage in direct sunlight.
Do not store together with oxidizing and acidic
materials.
Section 8 – Exposure Controls and Personal Protection
Engineering Controls
Use local exhaust ventilation or other engineering
controls to control sources of dust, mist, fumes and
vapor.
Keep away from heat and open flame. Store in a
cool, dry place.
Personal Protective Equipment
Respiratory Protection: Not necessary under
THIS DOCUMENT WAS REDACTED WITH THE PRODUCTIP REDACTION TOOL ON 2021-05-14. AT THE TIME OF GENERATING THE DOCUMENT THE ORIGINAL DOCUMENT WAS AVAILABLE ALSO. THE ORIGINAL CAN ONLY BE MADE AVAILABLE BY THE DOCUMENT OWNER.