User's Manual

FCC Warning

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference,

and (2) this device must accept any interference received, including

interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible

for compliance could void the user's authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates uses and can radiate radio

frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the

following measures:

 -Reorient or relocate the receiving antenna.

 -Increase the separation between the equipment and receiver.

 -Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

 -Consult the dealer or an experienced radio/TV technician for help.

Specific Absorption Rate (SAR) information:

This Feature Phone meets the government's requirements for exposure to

radio waves. The guidelines are based on standards that were developed by

independent scientific organizations through periodic and thorough evaluation

of scientific studies. The standards include a substantial safety margin designed

to assure the safety of all persons regardless of age or health.

FCC RF Exposure Information and Statement

The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue.

Device types: Feature Phone (FCC ID: 2AGAK-C2U) has also been tested against

this SAR limit. The highest SAR value reported under this standard during

product certification for use at the ear is 0.889W/kg and when properly worn on

the body is 0.637W/kg. This device was tested for typical body-worn operations

with the back of the handset kept 10mm from the body. To maintain

compliance with FCC RF exposure requirements, use accessories that maintain

a 10mm separation distance between the user's body and the back of the

handset. The use of belt clips, holsters and similar accessories should not

contain metallic components in its assembly. The use of accessories that do not

satisfy these requirements may not comply with FCC RF exposure requirements,

and should be avoided.