Instructions / Assembly

Installation & Assembly Instructions
Please contact our Customer Service Division with any questions at:
30700 D Carter Street ∙ Solon, OH 44139 ∙ (P) 440.248.5480 ∙ [e-mail]
For a full line of products visit www.tritonproducts.com 2 INS3536
3. Starting from the Upper Frame slide a 3/8”-16x2-1/2” Tap Bolt through the top towards the Bottom Frame. Slide
(1) 3/8” Flat Washer, (1) 3/8 Lock Washer, and (1) 3/8-16 Hex Nut on the Tap Bolt from the Lower Frame.
Tighten using a 9/16” Wrench/Socket.
4. With a second person to help, align the holes in the side of the assembled leg with the holes in the side of the
Lower Frame piece (Triangular Support facing outward). Choose desired height, and slide a 3/8”-16x2-1/2” Tap
Bolt through the outside of the frame. On the inside of the leg piece, slide (1) 3/8” Flat Washer, (1) 3/8 Lock
Washer, and (1) 3/8-16 Hex Nut. Tighten using a 9/16” Wrench/Socket. (Repeat for other side).
5. To install the handle, place the handle over the 4 holes in the side of the frame (2 in the upper frame and 2 in
the lower frame) and slide (1) Philips Head Bolt, (1) 1/2” Flat Washer, (1) 1/2 Lock Washer, and (1) ½” Hex Nut.
Tighten using a 9/16” Wrench/Socket.
6. To install the Casters, slide the caster through the foot assembly piece, and place a 3/8” Flat Washer, and 3/8”
Hex Nut. Tighten. Repeat this step for the rest of the casters.
7. Using the second person to help, stand the unit up.
8. To install the pegboards, hold the board to the frame. Using the existing holes in pegboard and self-drilling
screws. Square up pegboard with the outside edge of your frame section. Using an electric drill with a high
performance #1 or #2 Phillips bit, install self-drilling screws into each of the corners opposite arm assemblies;
complete installation. Repeat step for other boards. To help expedite installation of your pegboard: You may
want to pre-drill where tap screws are to be installed using a 1/8”drill bit. Spread screws throughout all edges of
all 4 boards.
9. Place the Plastic End Caps inside the 2 openings on the Upper Frame, the openings at the end of each Foot
Assembly Base, the openings at the top of each Upright Assembly.
Warranty information: Triton Products warrants to the original owner that this product is free from defects in material
and workmanship for a period of two years from the date of the original purchase. If this product is defective when used
as intended under normal household conditions within the specified period, Triton will replace the product, send a
replacement part or issue a refund (at our option) when the consumer provides a proof of purchase (either a bill of sale,
receipted invoice or other proof that the product is within the warranty period), along with a full description of the
defect.
Liability: Triton Products and/or its Reseller’s liability are limited to 100% of the purchase price of the product.