User's Manual

Portable Router
PAGE 16 OF 44
3.1.3 LAN Settings
Choose Basic Settings > LAN Settings, you can configure LAN parameters, you can
also modify these parameters according to your need, you may can not access the
router’s WEB page when you modified the LAN IP address, don’t worry, you can modify
your PC’s IP address as same subnet as gateway.
¾ LAN IP Address: Enter the IP address of your router (factory default:192.168.100.1).
¾ Subnet Mask: An address code that determines the size of the network, normally use
255.255.255.0 as the subnet mask.
Note:
1. If you change the IP address of LAN, you must use new IP address to login the router.
2. If the LAN IP address you set is not in the same subnet, the IP Address pool of the
DHCP server will change accordingly at the same time, while the Virtual Server and
DMZ Host will not take effect until they are re-configured.
3.2 Wireless Settings
3.2.1 Basic Settings
Choose Wireless Settings > Basic Settings, here you can configure basic wireless
parameters.
¾ Mode: This field determines the wireless mode which the Router works on, there
are five options, the default value is 802.11b/g/n.