INSTALLATION GUIDE & USER’S MANUAL ISLAND MOUNT RANGE HOOD Model: Pro-X Series PX01-I30 / I36 / I42 IMPORTANT: READ AND SAVE THESE INSTRUCTIONS FOR RESIDENTIAL & INDOOR USE ONLY www.XtremeAirUsa.
TABLE OF CONTENTS 1 IMPORTANT SAFETY INSTRUCTIONS ......................................................................................................................... 2 2 HEIGHT & CLEARANCE ............................................................................................................................................ 3 3 VENTING REQUIREMENT ..........................................................................................................................................
2. HEIGHT & CLEARANCE 3. VENTING REQUIREMENTS IMPORTANT: NEVER exhaust air or terminate ductwork into crawl spaces, between walls, ceiling, attics or garages. All exhaust must be ducted to the outside. Hood mounted too low could result in heat and/or fire hazard. Hoods mounted too high will be hard to reach and will lose its performance and efficiency. Use metal ductwork only. DO NOT use plastic ventilation. DO NOT use 4” (10.2 cm) laundry-type wall caps.
7. PARTS SUPPLIED PART SKETCH 8.
9. INSTALLATION STEP #2: INSTALLING “CEILING BRACKET” A. Cut out a hole in the ceiling where the ducting will go. B. Prepare support framework for ceiling bracket. C. Place chimney bracket against ceiling & screw it into place. D. Drop the ducting and electrical work through the ceiling. STEP #1: MARKING “CEILING BRACKET” A. Put a thick, protective covering over counter top, cook top or Range to protect from damage or debris. B. Find and mark the center point directly above your cook top. C.
STEP #6: INSTALLING OIL TUNNEL & BAFFLE FILTERS 1 1. Angle (higher point) baffle filter toward front of hood (oil tunnel side). OIL TUNNEL: Drop oil tunnel into the inside hood body slot. 2. Lift the lower angle of the baffle filter up above horizontal level. 3. Slide (backward) forward into slot. To remove the baffle, please reverse the process. 10. RANGE HOOD OPERATION IMPORTANT: BEFORE YOU BEGIN 1. This unit is equipped with TOUCH SENSITIVE CONTROLS so please DO NOT PRESS.
A. ACTIVATING BLOWER FUNCTION: Option 1: Touch and hold down (+) for 1-2 seconds. Option 2: Touch and hold down power sign (1) for 1-2 seconds. (The blower will be running at the same speed as last used). Note: The system saves user configurations, settings such as timer and blower (motor) speed will remain the same the next time it is turned on. B. ADJUSTING BLOWER SPEED: Touch and hold down (+) for increase. Touch and hold down (-) for decrease. C.
3. The blower or fan seems weak: Check that the duct sized used is at least 6”. Range hood WILL NOT function efficiently with insufficient duct size & loosely secured. Check if duct is clogged or if damper unit (half-circular flapper) is not installed correctly or opening properly. A tight mesh on a side wall cap unit might also cause restriction to the air flow. 4. The lights work but the blower is not spinning at all, is stuck or is rattling.
15. LIMITED WARRANTY www.XtremeAirUsa.
