Use and Care Manual

General Safety
WARNING!
Please
read
this ins
truction before using, and strictly follow the listed instructions below, to
avoid
electric shock, fire
and other serious injury.
1. Do not use in the wet or humid environments.
2. Do not near flammable and explosive liquids, gases or dust.
3. Do not use on a power supply without a grounding device or surge protector, the outlet must be grounded
reliably, to prevent electric shock when using.
4. Do not refit plug.
5. The
magnetic
drill should be tied with safety rope while occupations at slope, vertical, top surface
or
elevated
heights. To prevent accidents caused by falling of machine because of sudden power failure or outage when
using.
6. Children, bystanders and animals should be kept a safe distance away from the machine while in use.
7. Do not use together with welding machine on the same surface to prevent electric shock.
8. Do not use on rough surface, because it
will
reduce
suction of
magnetic.
9. Please
kindly
check the suction of the magnetic
if
it is enough to retain working. There will be dramatic decline
about the suction of magnetic if the working on steel plate which thickness is less than 20mm.
10. Please keep hair and clothes away from the rotating parts when using the machine.
11. The power cord should be kept away from rotating parts when the machine is in use.
12. The operator
should
wear goggles when the machine is in use.
• When you are finished using the machine, you must turn the power off and unplug the
machine or when making
adjustments or cleaning the machine.
When working with steel, you must check the thickness of the steel pieces, (must be thicker than the 20mm, less
magnetic material must add the steel material,) you must lie the safe bell.
Use only manufacturer approved accessories with the magnetic drill.
For the machine keep the good condition, please the original accessories.