Use and Care Manual

D. lnstall the required drill and loosen the dial and tighten the top screws. Turn the
rack so that the drill
can
align the holes
and
tighten the
top
screw. Rotate supporting
bar.
E. Open the drill control switch for the drilling process. (Note: The feed is generally
0.55mm/r, not too much force in order to prevent overload. F.
When processing is complete, turn off the control switch and magnet control switch
and pick up magnetic drill from work surface.
Maintenance
1. Add oil frequently and keep the gear box and bearing clean.
2. Maintain the magnetic drill frequently. Check the magnet suction, drill, power
plugs, indicator lights, switch, insulation, resistance whether normal, the guide plate
movement whether normal.
3. Save each part.
4. Magnet drill should be stored upright in a dry,clean surface away from corrosives
and flammable matierials.
5