COMPACTOR 6HP ITEM: 61019 OWNER’S MANUAL AND SAFETY INSTRUCTIONS SAVE THIS MANUAL: KEEP THIS MANUAL FOR SAFETY WARNINGS, PRECAUTIONS, ASSEMBLY, OPERATING, INSPECTION, MAINTENANCE AND CLEANING PROCEDURES.
IMPORTANT SAFETY INFORMATION GENERAL SAFETY WARNINGS Read all safety warnings and instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference.
IMPORTANT SAFETY INFORMATION Operate the plate compactor on flat, level surfaces only. Turn the engine OFF when the compactor is not in use. DO NOT operate or service this machine before reading this entire manual. Never operate this equipment without proper protective clothing, shatter proof ANSI-approved glasses, steel-toed boots, and other protective job site devices. NEVER operate the equipment while under the influence of medication, drugs or alcohol.
INTRODUCTION APPLICATIONS The Plate compactor is a machine that compacts the ground and it intends to make the surface smooth, by transmitting vibration through vibrating plate, which power generated from single motor in vibrator case This machine is suitable for making the ground surface smooth, such as leveling the soil and beaching, finishing the asphalt paving.
PARTS DIAGRAM 4
PARTS LIST 5
PARTS DIAGRAM - VIBRATOR ASSEMBLY 6
OPERATION PRIOR TO OPERATION Make sure that all dirt, mud, etc., are thoroughly removed from the unit prior to operation. Special effort should be given to the bottom face of the vibrating plate and those areas adjacent to the cooling air inlet of engine, carburetor and air cleaner. Check all bolts and screws for tightness and make sure all bolts and screws are securely tightened. Loose bolts and screws may cause damage to the unit. Check the V-belt for tightness.
OPERATION GASOLINE ENGINE 1. Turn the STOP SWITCH clock-wise to the position “I” (ON). 2. Open the fuel cock. 3. Set the speed control lever 1/3 to 1/2 of the way towards the high speed position. 4. Close the choke lever. If the engine is warm or the ambient temperature is high, open the choke lever half-way, or keep it fully open. If the engine is cold or the ambient temperature is low. Close the choke lever fully. 5. Pull the starter handle slowly until resistance is felt.
OPERATION 1. As the engine warms up,gradually move the choke lever to the OPEN position. 2. Move the speed control lever from the LOW to the HIGH position. When the engine speed reaches approximately 2,300-2,600 RPM,the centrifugal clutch engages. If the engine speed increased very slowly,it is possible that the clutch can slip. Do not operate the speed control lever slowly.
STORAGE AND MAINTENANCE STORAGE FLAMMABLE LIQUID: Stop engine and do not smoke or allow work in immediate area when refuelling. Fire or explosion could result from flames or sparks. MOVING PARTS: Shutdown engine before performing service or maintenance. Contact with moving parts can cause serious injuries. HIGH TEMPERATURES: Allow machine and engine to Cool before performing service or maintenance. Contact with hot components can cause serious burns.
MAINTENANCE CARE AND PREVENTATIVE MAINTENANCE Check the oil level in the motor crankcase daily. Check the vibrator oil level weekly. Inspect the rubber anti vibration mounts for wear or deterioration Clean the underside of the plate regularly to prevent a build up. Clean the underside of the plate regularly to prevent build up. Change the oil in the motor crankcase regularly to minimise wear. Inspect, clean and/or replace the motor air cleaner regularly, particularly when operating in a dusty environment.
TROUBLESHOOTING 12
WARRANTY THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT.