Replacement Part List

6
OPERATION
1. Push the fuel switch to “ON”.
STARTING THE ENGINE
2. Push the chock lever to
“OFF”.
3. Move left the throttle lever
slightly to FAST position.
ROPE HANDLE STARTER: Push the engine switch to “ON”. Pull slightly the starting rope handle up until
feeling anti-action, and then make a rapid pull. Releasing the handle suddenly may make it hitting the
engine. Release the handle slowly conforming to its recoiling force.
ELECTRIC STARTER: Push the engine switch to “START” and remain there until the engine Start.
CAUTION: Use the engine switch not more than 5 second each time to avoid damage of the engine. Try
once more 10 second later after last attempt failures. Once the engine starts, reset the engine switch to “ON”.
1. Preheat the engine and push back the 2. Set
the throttle lever in proper position to ensure
choke lever to “ON”.
2. Set the throttle lever in proper position to ensure
choke lever to the engine runs at required velocity.
4. Start the engine. a) Push the engine switch to the ON position. b) Pull slightly the starting rope handle
up until feeing anti-action, and then make a rapid pull. Return the starting rope handle gently to prevent
damage to the starter.
5. Gradually move the choke lever to the OPEN position. Warm up the engine until it runs smoothly.
6. Set the throttle lever in proper position to ensure the engine runs at required velocity.