Replacement Part List

3
IMPORTANT SAFETY INFORMATION
The engine of this chainsaw is designed to run on a mixed fuel which contains highly ammable
gasoline. Never store cans of fuel or rell the fuel tank in any place where there is a broiler, stove, re,
electrical sparks, welding sparks or any other source of heat or re which may ignite the fuel.
If any fuel spillage occurs during refuelling use a dry rag to wipe up spills before turning the engine
on.
After refuelling, screw the furl cap back on tightly onto the fuel tank and the carry the product to an area
that is approximately 10 feet away from where it was refuelled before turning the engine on.
Keep handles dry, clean and free of oil or fuel mixture.
NEVER touch the mufer, spark plug or other metallic parts of the engine while the engine is in
use or immediately after stopping the engine. Doing so can result in serious injury.
In order to maintain your product in proper working order, perform the maintenance and check operations
described in the manual at regular intervals.
Always be sure to turn off the engine before performing any maintenance procedures.
Chainsaw work is strenuous, if you have a condition that may be aggravated by extended use of the
chainsaw, check with your doctor prior to using the chainsaw.
Gasoline is an extremely ammable fuel. If spilled or ignited by a spark or other ignition source,
it can cause re and serious burn injury or property damage. Use extreme caution when handling
gasoline or fuel mix.
Fuel your chainsaw in well-ventilated areas, outdoors only. Always shut off the engine and allow
it to cool before refuelling. Gasoline vapor pressure may build up inside the gas tank of the engine
depending on the fuel used, the weather conditions, and the venting system of the tank. In order to
reduce the risk of burns or other personal injury from escaping gas vapor and fumes, remove the fuel
ller cap on this chainsaw carefully so as to allow any pressure build-up in the tank to release slowly.
Never remove fuel ller cap while engine is running.
Check for fuel leakage while refuelling and during operation. If fuel or oil leakage is found, do not
start or run the engine until leak is xed and spilled fuel has been wiped away. Take care not to get fuel
on your clothing. If this happens, change your clothing immediately.
To reduce the risk of personal injury from loss of control or contact with the running chain, do not use a
saw with incorrect idle adjustment. At correct idle speed, the chain should not rotate.
After adjusting a chain, start the saw, let the engine run for a while, then switch engine off and
recheck chain tension. Proper chain tension is very important at all times. Operate the chainsaw
under good visibility and daylight conditions only.
After adjusting a chain, start the saw, let the engine run for a while, then switch engine off and
recheck chain tension. Proper chain tension is very important at all times. Operate the chainsaw
under good visibility and daylight conditions only.