Replacement Part List

DIAGRAMS AND SPECIFICATIONS

GUIDE BAR AND SAW CHAIN PARTS LIST: A standard chainsaw unit package contains the

items illustration in Figure F1. Open the box and install the guide bar and the saw chain on the

power unit as follows.

1. POWER UNIT

2. BAR PROTECTOR

4. CHAINSAW

5. PLUG WRENCH

6. SCREWDRIVER FOR CARBURETTOR ADJUSTMENT

7. SPIKE AND MOUNTAIN SCREWS

The chainsaw has very sharp edges. Use thick protective gloves for safety.

WARNING: The features include on your chainsaw are to help prevent the hazard of kickback; however,

such features will not eliminate this danger. As a chainsaw user, do not rely only on safety devices

alone. You must follow all safety precautions, instructions and maintenance in this manual to help avoid

kickback and other forces which can result in serious bodily injury.

3. GUIDE BAR

1. Pull the guard towards the front handle to check the

chain brake is not on.

2. Loosen the nuts and remove the chain cover.

4. Gear that chain to the sprocket and while tting the

chain saw around the guide bar, mount the guide bar to

the power unit. Adjust the position of the chain tensioner

nut on the chain cover to the lower hole of the guide bar.

(F2)

3. Install the attached spike to the power unit.

(8) Hole (9) Tensioner Nut (10) Chain Cover

1. Moving direction

2. Fit the chain cover to the power unit and fasten the nuts

to nger tightness.

4. Tighten the nuts securely with the bat tip held up (12-

15N.m). Then check the chain for smooth rotation and

proper tension while moving it by hand. If necessary,

readjust with the chain cover loose.

3. While holding up the tip of the bar, adjust the chain

tension by turning the tensioner screw until the tie straps

just touch the bottom side of the bar rail. (F4)

Pay attention to the correct direction of the saw

chain. (F3)

5. Tighten the tensioner screw.

(2) Loosen (3) Tighten (4) Tensioner Screw