Use and Care Manual

OPERATION

CFPT includes

Flow sensor:

Temperature sensor:

Salt sensor

Mark: The salt reading is around +/-300 ppm accuracy.

CFPT Dual Voltage 115V-230V Power Center

CFPT Power Center is a dual voltage power supply which means 115V/230V no wiring is required, The Power

Supply converts AC electrical current to a low-voltage DC electrical current which is required to produce

chlorine.

The Power Center contains the transformer, fuse ,connector to the cell and the AC electrical current wiring

conguration with the DC electrical current output cable to CFPT. A fuse is mounted in the enclosure for

additional protection. For information about installing and proper use of the Power Center, see the “CFPT

installation”

WARNING: CHLORINE GAS BUILDUP CAN OCCUR WITH IMPROPER WIRING:

To reduce the risk of personal injury, the Power Center

must be installed on and wired to the load side of the

time clock, electronically controlled switch, or relay

load side, so that it will receive power only when

the pool pump is on. Otherwise, dangerous chlorine

gas buildup can occur. The CFPT should never be

energized when the pool pump is OFF and water is

not owing through the unit.

Ensure to Install Chlorine/Bromine Feeders after CFPTCell

When using the CFPT with an in-oor cleaning system, it is recommended that a separate return line be used

for the cleaner to reduce the increased water pressure stress on the CFPT cell.

Loop Plumbing Diagram

CFPT is designed to operate with water ow rates from 25+/-5 gallons per minutes (gpm)

up to 105 gpm. Over 80 gpm you must use a bypass loop for the best chlorine production.

Installations with ow rates over 80 gpm include those that have in-oor cleaning systems

or booster pumps. These systems must use a bypass loop with the CFPT with a ow

control valve that assures that the ow through he CFPT is maintained within its designed

operating water ow rates.

● Always install the CFPT AFTER the lter and heater. The CFPT should be at least three

(3) feet away from the heater outlet.

● If CFPT is installed on a pool/spa combination system, install (see diagram

below) BEFORE the pool/spa return valve to allow proper chlorination of both the

pool and spa and also to avoid creating gas being trapped in the pool plumbing.

● Horizontal install the CFPT cell.