Use and Care Manual

OPERATION

Fan Operation: Always operate the fan in the

upright position following all instructions and

recommendations listed in this manual.

Fan Location: Place the fan in the area of the

room that will provide proper fan cooling.

Fan Connection: Plug fan directly into 120

volt A.C., 60 Hz wall outlet. Be sure plug ts

tightly in outlet. A loose connection may cause

overheating and damage to the plug or fan.

NOTE: To prevent overloading a circuit, do not

plug the fan into a circuit that is servicing other

electrical needs.

Turning Fan On: Place fan on stable level surface. Plug fan into properly grounded outlet. To start

the fan, turn the switch from the OFF position to the desired fan speed.

FIG. 1 FIG. 2

Turning Fan Off: To turn the fan off, turn the switch from the current fan speed setting to the off

position. Remove plug from outlet.

Adjusting Fan Tilt: To adjust the tilt angle, use supplied knob wrench to loosen the adjustment

screw. After adjustment, retighten the adjustment screw. Save knob wrench for future use.

Fan Cradle Assembly: Simple assembly is required to use this fan.

1. Align Cradle Base (packed separately) with support brackets attached to fan body sides. Note: you

may need to ex the parts to make them align properly.

2. Insert support bracket into opening of Cradle Base. Press spring loaded button down to allow it to

insert into Cradle Base, see Fig 1.

3. Press support bracket into Cradle Base until spring button protrudes out open hole in Cradle Base,

see Fig. 2.

4. Repeat above process for opposite side of fan.

This product employs overload protection (fuse). A blown fuse indicates an overload or short‑circuit

situation. If the fuse blows, unplug the product from the outlet. Replace the fuse as per the user

servicing instructions (follow product marking for proper fuse rating) and check the product. If the

replacement fuse blows, a short‑circuit may be present and the product should be discarded or

returned to an authorized service facility for examination and/or repair.

Fuse Replacement:

1. Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling on cord.

2. Open fuse cover by sliding open fuse access cover on top of attachment plug towards blades. See

Fig. 2.

3. Remove fuse carefully. Use a small tool to pry the end of the fuse from holder cavity. Be careful

not to break glass window.

4. Replace fuse. WARNING: Risk of re. Replace fuse only with identical 2.5 or 5.0 Amp, 125 Volt

fuse (3.6mm x 10mm). Be sure fuse is properly seated within its cavity.

5. Close fuse cover by sliding it back to its original closed position.