Instructions / Assembly

10
ASSEMBLY
NEVER connect an unregulated propane cylinder to the heater.
A dented, rusted or damaged propane cylinder may be hazardous and should be checked by the cylinder
supplier. NEVER use a propane tank with a damaged valve connection.
Attach the regulator to the cylinder. Complete attachment.
Install the cylinder.
• Perform all leak tests outdoors • Extinguish all open ames • NEVER leak test while smoking
• DO NOT use the heater until all connections have been leak tested and found to not leak.
LEAK CHECK
• Make 2-3oz of leak check solution (one part dish soap to three parts water).
• Apply several drops where the hose attaches to the regulator, do the same for the area where the regulator
connects to the cylinder.
• Make sure all heater and light valves are OFF.
• Turn the cylinder valve ON. If any bubble appear, there is a leak. Turn the cylinder valve OFF.
• If the leak is at the cylinder hose/regulator connection: Disconnect, reconnect and perform another leak
test. If you continue to see bubbles after several attempts, the cylinder valve is defective and should be
returned to the place of purchase.
• If NO bubbles appear at any connection, the connections are secure.
• Turn the cylinder valve OFF and complete installation.
NOTE: Whenever the gas connections are loosened or removed, you must perform a complete leak test.