Instructions / Assembly

ASSEMBLY

Step 7 - Attach Head Assembly to Post

1. Screw off four small screws, then load head assembly by inserting the hose into the post. The control

knob should be above on the post. Attach the head assembly to the post and loosely install four small bolts,

thightening them securely. Then fasten the lower post and upper post with four M5x10 screws.

Step 8 - Install the Reector

NOTE: Leave all screws and nuts loose until the entire shield is put together to ensure proper alignment.

Tighten after sections are aligned.

1. Slide the two reector panels together then insert one small screw.

2. Place the reector center plate into the middle of the reector panels and repeat the procedure above.