Use and Care Manual
ASSEMBLY
2
PREPARATION
Before beginning assembly, make sure all parts are present. Compare all parts against the contents list
and hardware are represented in the contents. If any parts are missing or damaged, do not aempt to
assemble the heater. Contact customer service for replacement parts.
Tools required for assembly, not included:
• Phillips screwdriver with medium blade • Leak test soluon
ATTACHING THE ANCHORING ARM:
Aach one anchoring arm to the base with 2
screws and nuts as shown. Repeat with the other
2 anchoring arms so all three are aached to the
base.
To anchor the heater to the ground, insert anchoring
[ins through the anchoring arms and directly into
the ground as shown.
STEP 1: Aach wheel assemble K to base J. Align holes in
the wheel assembly with corresponding holes in the base
and insert 2 medium bolts through the holes and nger
ghten. Conrm that the wheel assembly is parallel to the
base J and ghten with a wrench.
Hardware used: 2 x medium bolts
STEP 2: Aach the post supports I to the base J. Align the
holes in the boom of each post support with the hole
on the base. Insert 1 medium bolt through the hole in the
support and into the base and hand ghten. Repeat with
the other 2 post supports and ghten bolts with a wrench.
Hardware used: 3 x medium bolts
STEP 3: Aach the lower post G to the post supports I. Once
you have ghtened the bolts holding the post supports I
to the base J. Align the holes in the lower post G with the
holes on the tops of the post supports and inset a large bolt
through the hole in the post support. Secure with a small
ange nut. Repeat this with in the 5 remaining holes. (6
holes total. 2 for each post support piece). Hand ghten
with the wrench when all bolts have been inserted.
Hardware used: 6 x large bolts | 6 x small ange nuts