Use and Care Manual

ASSEMBLY
1 2
STEP 4: Aach upper post F to lower post G by screwing the
two pieces of the post together.
Hardware used: 3 x Reector studs | 3 x Large at washers
STEP 5: Slide tank housing D over the assembled upper/
lower posts F/G and down over the post supports I. Rest
the tank housing on the base J.
STEP 6: Aach the reector studs to the top of the head
assembly C. Insert 1 reector stud through 1 large at
washer and into the hole on top of the head assembly C.
Tighten stud securely. Repeat with the other 2 reector
studs.
Hardware used: 4 x small bolts with lock washers
STEP 7: Aach head assembly C to upper post F. Loosen or
remove the 4 small bolts with lock washers pre-installed in
the neck of the head assembly. Route the gas hose E down
into the upper/lower posts F/G and align 4 small holes on
the head assembly C with the four small holes in the upper
post F. Insert 4 small bolts with lock washers through the
aligned for holes and ghten securely with a wrench.