Instructions / Assembly

OPERATION

CARBON MONOXIDE HAZARD: For outdoor use ONLY. NEVER use inside the house or other

unventilated or enclosed areas. This re pit consumes air (oxygen). DO NOT use in unventilated

or enclosed areas to avoid endangering your life.

CAUTION: DO NOT attempt to operate until you have read and understand all General Safety Information

in this manual and all assembly is complete and leak checks have been performed.

BEFORE TURNING THE GAS SUPPLY

1. Your re pit was designed and approved for outdoor use only. DO NOT use it inside a building, garage or

any other enclosed area.

2. Make sure surrounding areas are free of combustible materials, gasoline and other ammable vapors or

liquids.

3. Ensure that there is no obstruction to air ventilation. Be sure all gas connections are tight and there are

no leaks.

4. Be sure the cylinder cover is clear of debris. Be sure any component removed during assembly or servicing

is replaced and fastened prior to starting.

BEFORE LIGHTING

1. The re pit should be thoroughly inspected before each use and by a qualied service person at least

annually. If relighting a hot re pit, always wait at least 5 minutes.

2. Inspect the hose assembly for evidence of excessive abrasion, cuts or wear. Suspected areas should

be leak tested. If the hose leaks, it must be replaced prior to operation. Only use the replacement hose

assembly specied by the manufacturer.

LIGHTING

1. Turn the control knob to the OFF position.

2. Fully open the LP cylinder valve. Note: for initial start or after any cylinder change, hold the control knob

IN for 2 minutes to purge air from gas lines before proceeding.

3. Push in the gas control knob and turn it counter-clockwise to IGNITOR to light the re pit. If needed keep

depressing and turning the control knob counter-clockwise until the heater lights. ( You should hear a clicking

noise).

4. After the re pit lights, release the control knob. Push in and turn the control knob to the HIGH position,

then release the control knob. If you want to lower the temperature, push in the control knob and turn

counter-clockwise to the LOW position.

NOTE: If the burner fails to remain lit, all valves should be closed and a waiting period of at least 5 minutes

should pass before attempting to light.