Use and Care Manual

OPERATION

It is a good idea to re the heater outdoors for the rst time. This will allow any oils used in the manufacturing

process to be burned off in a safe place. This initial burn should last at least 10 minutes.

VENTILATION : ALWAYS provide fresh air opening in the heated soace of at least three square feet for each

29KW/hr of heater output.

STARTING THE HEATER:

1. Fill the tank with fuel up to fuel guage points to “F”. MAke sure the cap is secure.

2. Plug the power cord into a local, correct plug. The extension cord should be at least 6 feet long. Extension

cord requirements are as follows:

6-10ft : 18 AWG wire. 11-100ft : 16 AWG wire. 101-200ft : 14 AWG wire.

3. Turn the thermostat control knob to the desired setting. The setting range is from 40 °F to 110 °F. Push

the power switch to the ON position. The power indicator lamp and room temperature display will light up

and the heater will start.

If the heater does not re, the thermostat may be set too low. Turn the control knob to a higher setting until

the heater res. If the heater does not start, push the power switch to OFF, then back to ON. If the heater still

does not re, see the Troubleshooting guide.

NOTE: The electrical components of this heater

are protected by a fuse mounted in the PC

board. If the heater fails to re, chek the fuse rst

and replace if necessary. Also check the power

source to be sure that the proper voltage is being

provided to the heater.

STOPPING THE HEATER:

Simply turn the power switch to the OFF position and unplug the power cord.

STOPPING THE HEATER:

1. Wait 10 seconds after shutting off the heater.

2. Turn the power switch to ON position.

3. Be sure to follow all starting procedure precautions.