Use and Care Manual

IMPORTANT SAFETY INFORMATION
3
SAVE THESE WARNINGS
The heater is designed and approved for use as a construction heater in accordance with the Standard
for Gas-Fired Construction Heaters ANSI Z83.7 ● CSA 2.14. CHECK WITH YOUR LOCAL FIRE
SAFETY AUTHORITY IF YOU HAVE QUESTIONS ABOUT APPLICATIONS. Other standards govern
the use of fuel gases and heat producing products in specific applications. Your local authority can advise
you about these.the intended use is the temporary heating of a building or structure under
construction,alteration, or repair.
Keep children and animals away from heater. Never move, handle or service a hot or operating heater.
Severe burns may result. Wait 15 minutes after turning heater off. To prevent injury,wear gloves when
handling heater. Turn off propane supply to heater when not in use. Use only original replacement parts.
This heater must use design-specific parts. Do not substitute or use generic parts.Improper replacement
parts could cause serious or fatal injuries. Installation of this appliance at altitudes above 2000 ft (610 m)
shall be in accordance with local codes, or in the absence of local codes, the National Fuel Gas Code,
ANSI Z223.1/NFPA 54, or National Standard of Canada, Natural Gas and Propane Installation Code, CSA
B149.1..The heater should be inspected before each use, and at least annually by a qualified service
person.
NEVER refill the heater’s fuel tank while heater is operating or still hot. This heater is EXTREMELY HOT
while in operation. Keep all combustble materials away from this heater.
NEVER use duct work in front or at the rear of the heater.
NEVER transport the heater with fuel in its tank.
Bulk fuel storage should be a minimum of 25 feet away from the heater, torches, portable generators or
other sources of ignition.
ALWAYS locate the heater on a stable, level surface.
RISK OF ELECTRICAL SHOCK! Use only the electrical power (voltage and frequency) specified on the
model plate of the heater. Use only a local, correct plug and a grounded outlet and extension cord.
ALWAYS install the heator so that is is not directly exposed to water spray, rain, dripping water or wind.
ALWAYS unplug the heater when not in use.