User manual

6
TURNING THE SPEAKER POWER ON/OFF
1. In standby mode, tap the POWER button to turn on the unit, the power
button backlight will light up green and begin blinking slowly.
2. In power on mode, tap the POWER button to turn the unit off, the green
power button backlight turns off.
Note: Before first use, please charge the speakers for at least 4 hours
because the batteries may not fully charged, even though the charging LED
lights.
OOTH OPERATIO
BLUETOOTH OPERATION
Power on the unit and follow the directions below to use the A2DP profile Bluetooth
features of this unit.
Turn on the Bluetooth
In Bluetooth Off mode, press and hold the Bluetooth button for about 5 seconds until
a beep sound is heard and the Bluetooth button backlight flashes blue.
Note: Press and hold the Bluetooth button for about 9 seconds to change to
Bluetooth pairing (linking) mode. The Bluetooth button backlight will flash blue
and red.
Turn off the Bluetooth
In Bluetooth ON mode, press and hold the Bluetooth button and hold for about 3
seconds until a beep sound is heard and the Bluetooth button backlight flashes red
and then all lights go off.
PAIRING (LINKING) A BLUETOOTH ENABLED MOBILE PHONE OR OTHER
BLUETOOTH ENABLED DEVICE TO THE WOOMBOX
1. With the power on and Bluetooth Off , press and hold the Bluetooth button for
about 9 seconds until a second beep sound is heard, The Bluetooth button
backlight will flash blue and red. The WOOMBOX is ready to pair (link) with your
Bluetooth device.
2. Turn on the Bluetooth feature of your mobile phone and enable the search or
scan feature to find the WOOMBOX.
3. Select "WOOMBOX" from the device list when it appears on your screen. If
required, enter the pass code “0000” to pair (link) the WOOMBOX with your
mobile phone.
4. After successfully pairing (linking) your mobile phone with the WOOMBOX, you
can play music from your mobile phone wirelessly to the WOOMBOX.