User Manual

Operation
102
4.2.2 Salinity
To measure the salinity, proceed as follows:
1 Perform the preparatory activities according to sec-
tion 4.2.
2 Immerse the conductivity measuring cell into the test
sample.
3 Press the <ì> key repeatedly until Sal appears in the
status line. The salinity value of the sample appears
on the display.
4 If necessary, set the temperature by pressing
<
▲><▼> (see section 4.2, page 99).
5 Wait for a stable measured value.
6 Perform an AutoRead measurement according to
section 4.2.