User Manual

Operation
120
Note
The
AutoStore function is interrupted if you perform other
functions, e.g. output data storage.
After completing the other function, the
AutoStore function
continues. However, as a result, gaps can occur in the
recording of the measured values.
5 As soon as all 200 memory locations are full, the Au-
toStore function is terminated (Int 1 = OFF).
If too few storage locations are available for your
measurements:
– backup the data storage (see page 121) and
– clear the data stored (see page 127).
6 Confirm with <run/enter>.
The prompt for the I.D. number appears on the dis-
play.
7 Press <▲> <▼> to set the required I.D. number.
8 Confirm with <run/enter>.
The instrument changes to the measuring mode and
starts the measuring and storage procedure.
AutoStore flashes on the display.