User guide

Transmitting data (USB interface) HandyLab 600
56 ba77064e01 03/2014
9.4 Options for data storage to a PC
Via the USB-B interface you can store data to a PC. The following table shows
which data are transmitted to the interface in which way:
9.5 MultiLab Importer
With the aid of the MultiLab Importer software, you can record and evaluate
measurement data with a PC.
Data Control Operation / description
Current
measured
values of all
connected
sensors
Manual  With <F2>/[USB output].
 Simultaneously with every manual
data storage process (see section 8.1
M
ANUAL STORAGE, page 49).
Automatic, at
intervals
 With <F2__>/[USB output].
Then you can set the transmission
interval.
 Simultaneously with every automatic
data storage process (see section 8.2
A
UTOMATIC DATA STORAGE AT INTER-
VALS, page 50).
Stored mea-
sured values
Manual  Displayed dataset with <F2>[USB out-
put] after calling up from the memory.
 All datasets with the Output to RS232/
USB function.
(see section 8.3.1 E
DITING THE MEA-
SUREMENT DATA MEMORY, page 52).
Calibration
records
Manual  Calibration record with <F2>/[USB out-
put] (see section 5.2.6 C
ALIBRATION
DATA, page 30).
Automatic  At the end of a calibration procedure.
The following rule applies: With the exception of the menus, shortly
pressing the <F2>/[USB output] key generally outputs the display
contents to the interface (displayed measured values, measuring
datasets, calibration records).
More detailed information can be found in the MultiLab Importer
operating manual.