Instruction Manual

58
Specifi cations (HandyLab 750)
Diagnostics functions Sensor data
(Memosens only)
Manufacturer, sensor type, serial number,
operating time
Calibration data Calibration date, zero, slope
Device self-test Automatic memory test (FLASH, EEPROM, RAM)
Device data Device type, software version, hardware version
Data retention Parameters, calibration data > 10 years
Data transfer 1x Micro USB-B for data transfer to PC
Data logger With up to 5000 memory locations
Calibration data logger
MemoLog (Memosens only)
Recording: manual, interval- or event-controlled
Up to 100 Memosens calibration protocols recordable
- Records displayable
- Directly transferable via Memosuite (USB): manufacturer, sensor type, serial no.,
zero-point, slope, calibration date
Communication USB 2.0
Profi le HID, installation without driver
Use Data exchange and confi guration via HandyLab
Pilot software
Nominal operating
conditions
Ambient temperature –10 … +55 °C
Transport/ Storage temperature –25 … +70 °C
Relative humidity 0 … 95 %, short-term condensing allowed
Power Power supply Batteries 4x AA alkaline or 4x NiMH
(rechargeable) or 1x Li-ion-battery
Operating time approx 1000 h (Alkaline)
Housing Material
PA12 GF30 + TPE
Protection
IP66/67 with pressure compensation
Dimensions
approx. (132 x 156 x 30) mm
Weight
approx. 500 g
Licensing - Compliance - Equipment safety
EMC EN 61326-1 (General Requirements)
Emitted interference
Class B (residential area)
Immunity to interference
Industry
EN 61326-2-3 (Particular Requirements for Transmitters)
RoHS conformity According to directive 2011/65/EC
Display Sensoface Gives you indications about the status of the
sensor, analysis of zero-point/slope, setting time,
frequency of calibration. Status indication
(friendly, neutral, sad)
Display LCD STN 7-segment display with 3 lines and
icons
Status indicators Battery power level, logger
Notices Hourglass
Keypad
[on/off], [cal], [meas], [set], [], [
], [STO], [RCL],
[clock]
*) User-defi ned
1) Ranges depending on Memosens sensor
2) According to EN 60746-1, at nominal operating conditions
3) ± 1 count
4) Plus sensor error