User guide

Operation handylab pH 12

ba75368e04 01/2011

4.5 Transmitting data

You have the following possibilities of transmitting data:

z One of the following options:

– With the AutoStore function (page 36), measured values are

periodically saved internally (save interval Int 1) and output on the

interface.

– With the Data transmission interval function (Int 2), measured values

are periodically output on the interface (see below).

z With the Output data storage function (page 38), calibration data or saved

measured values are output on the interface.

z Via the analog recorder output (page 46), measured values are output as

voltage values.

z With a communication kit (accessory), data can be transmitted bidirection-

ally (page 47).

Note

If you connect a recorder (analog output), the output on the digital interface

is switched off.

4.5.1 Data transmission interval (Int 2)

The interval to the data transmission (Int 2) determines the chronological in-

terval between automatic data transmissions. After the selected interval ex-

pires, the current data record is transmitted to the interface.

Note

When the AutoStore function is active, the data transmission is performed ac-

cording to the setting of the save interval (Int 1). Set the save interval (Int 1)

to OFF to activate the Data transmission interval (Int 2).