Owner manual

GPRS iCE
3
, V1.30 User Guide
14 iQuest (NZ) Ltd - PO Box 15169, Hamilton, New Zealand Tel: [phone] Fax: [phone] Email: [e-mail]
AT^IDTO Data Forwarding Time Out
Description: Defines the data gap time (in milliseconds x10) after which the iCE
3
will forward the data
packet to the remote destination. This mode should be used for binary data packets as used
by iQuest products and Campbell Scientific dataloggers.
Default: 20 (200ms)
Notes: Range is 0-255 (0 -> 2.55 seconds). If this parameter is set to zero, then data will not be
forwarded unless a forwarding character is defined using the AT^IDFC command.
Mode Command Responses
Read AT^IDTO? ^IDTO: 0
OK
Write AT^IDTO=20 OK OR ERROR
Help AT^IDTO=? ^IDTO: (0-255)
OK
6.3.7 AT^IGOL Go On-Line
Description: Manually initiates connection to the GPRS network. Normally used after a command mode
session where parameters have been viewed or edited and reconnection is required.
Default: N/A
Notes: This command is write only.
Mode Command Response
Write AT^IGOL Connecting…
OK
6.3.8 AT^IHDT Host Device Type
Description: Defines the type of device that is connected to the host (RS232) port. Refer to Section 4.2
for details on how each of these device types work and Section 7 for cable information for each.
Default: 0 (Normal)
Notes: Range is 0-2 (0=Standard, 1=CSI datalogger, 2=Unidata datalogger)
Mode Command Responses
Read AT^IHDT? ^IHDT: 0
OK
Write AT^IHDT=0 OK OR ERROR
Help AT^IHDT=? ^IHDT: (0-2)
OK