Owner's manual

Installation, Operation and Maintenance Instruction Model LSB
LSB 100-english page 95 Revision 02
Artikel Nr. 771076129 Ausgabe 01/2010
Design: S1...2 Single mech. seal, unbalanced (DIN 24960, l
1k
/ EN 12756, design K, form U), Impeller with
back vanes
You find the shaft sealing of your pump on the data sheet / the order confirmation. Refer to chapter 3.1.1, Design
coding system, as well.
125-100-200 125-100-250 150-125-250 200-150-250
80-50-315 100-65-160 100-65-200 100-65-250 125-80-160 125-80-200 125-80-250
65-40-160 65-40-200 65-40-250 65-40-315 80-50-160 80-50-200 80-50-250
40-25-160 40-25-200 40-25-250 50-32-160 50-32-200 50-32-250 50-32-315
Valid for
Type:
Part name:
Volute casing
Casing cover
Support foot
Pump alignment
Stub shaft
Impeller
Motor lanterne
Gasket
O
-
ring
Mech. seal
Wear ring
Fixing ring
Washer
Bev
elwasher
Bevelcup
Washer
Guard plate
Flange motor
Hexagonal screw
Hexagonal screw
Hexagonal screw
Hexagonal screw
Stud
Grub screw
Grub screw
Grub screw
Grub screw
Drain plug
Hexagonal nut
Impeller nut
Key
No.
102 V
161
183 ***)
183P **)
210
230
341
400
412.21
433
502.11 *)
527 **)
554.41
554.42 ***)
554.43 ***)
554.44 ***)
681
801
901.11
901.31 **)
901.42
901.43 ***)
902.41
9
04.11 *)
904.31 **)
904.41
904.42
912.11
920.41
922
940.31
*) ... optional **) ... not for all designs ***) ... with IEC-Motor sizes: 160MA, 160M, 160L, 180M, 180L, 200L, 200LA, only
Subject to techn. alterations!
Not to scale!