Owner's manual
Table Of Contents
- 1 Overview
- 2 Safety instructions
- 3 Commissioning
- 4 Operation
- 4.1 Switching on or off the photometer
- 4.2 General operating principles
- 4.3 Photometer settings and system administration
- 4.4 Zero adjustment
- 4.5 Measuring in Concentration mode
- 4.5.1 Measuring cell tests with barcode
- 4.5.2 Measuring reagent tests with AutoSelector
- 4.5.3 Measuring reagent-free tests and user-defined methods
- 4.5.4 Exceeding the upper or lower limits of the measuring range
- 4.5.5 Selecting a method manually
- 4.5.6 Settings for Concentration mode
- 4.5.7 Measuring diluted samples
- 4.5.8 Sample blank value
- 4.5.9 Reagent blank value
- 4.5.10 Automatic Turbidity correction
- 4.5.11 Programming / modifying user-defined methods
- 4.5.12 The IQ LabLink procedure
- 4.6 Measuring the Absorbance / % Transmission
- 4.7 Multi wavelengths methods
- 4.8 Spectrum
- 4.9 Kinetics
- 4.10 Timer
- 4.11 Memory
- 4.11.1 Overview
- 4.11.2 Instructions on using USB memory devices
- 4.11.3 Measurement datasets
- 4.11.4 Saving measurement datasets manually
- 4.11.5 Saving measurement datasets automatically
- 4.11.6 Displaying measurement data memory
- 4.11.7 Filtering measurement datasets
- 4.11.8 Inverting filters
- 4.11.9 Erasing stored measurement datasets
- 4.12 Copying files
- 4.13 Transmitting data
- 4.14 Analytical quality assurance (AQA)
- 4.15 User management
- 4.16 Reset
- 4.17 Photometer information ([Info])
- 4.18 Lamp counter
- 4.19 Software and methods update
- 5 Maintenance and cleaning
- 6 What to do if ...
- 7 Technical data
- 8 Accessories and options
- Appendix
Operation photoLab
®
6100 VIS
106
ba75847e01 08/2009
4.11.5 Saving measurement datasets automatically
For the measuring modes, Concentration, Absorbance / % Transmission,
and Multi wavelengths you can record every measured value automatically
(AutoStore).
All automatically stored measurement datasets are given the ID "AutoStore".
The "AutoStore" ID is overwritten if the same measured value is manually
stored afterwards (<STORE>).
This ensures that every measurement dataset is stored in the data memory
only once.
Activating
AutoStore
Activate the AutoStore function as follows:
Note
The AutoStore setting is valid for all three measuring modes, Concentration,
Absorbance / % Transmission, and Multi wavelengths.
The available functions are
displayed.
1 Select and confirm AutoStore.
The AutoStore function is active
().
<HOME>
Concentration,
Absorbance / % Transmission, or
Multi wavelengths
– [Setup]
– Measurement data
memory
– Setup