Owner's manual
Table Of Contents
- 1 Overview
- 2 Safety instructions
- 3 Commissioning
- 4 Operation
- 4.1 Switching on or off the photometer
- 4.2 General operating principles
- 4.3 Photometer settings and system administration
- 4.4 Zero adjustment
- 4.5 Measuring in Concentration mode
- 4.5.1 Measuring cell tests with barcode
- 4.5.2 Measuring reagent tests with AutoSelector
- 4.5.3 Measuring reagent-free tests and user-defined methods
- 4.5.4 Exceeding the upper or lower limits of the measuring range
- 4.5.5 Selecting a method manually
- 4.5.6 Settings for Concentration mode
- 4.5.7 Measuring diluted samples
- 4.5.8 Sample blank value
- 4.5.9 Reagent blank value
- 4.5.10 Automatic Turbidity correction
- 4.5.11 Programming / modifying user-defined methods
- 4.5.12 The IQ LabLink procedure
- 4.6 Measuring the Absorbance / % Transmission
- 4.7 Multi wavelengths methods
- 4.8 Spectrum
- 4.9 Kinetics
- 4.10 Timer
- 4.11 Memory
- 4.11.1 Overview
- 4.11.2 Instructions on using USB memory devices
- 4.11.3 Measurement datasets
- 4.11.4 Saving measurement datasets manually
- 4.11.5 Saving measurement datasets automatically
- 4.11.6 Displaying measurement data memory
- 4.11.7 Filtering measurement datasets
- 4.11.8 Inverting filters
- 4.11.9 Erasing stored measurement datasets
- 4.12 Copying files
- 4.13 Transmitting data
- 4.14 Analytical quality assurance (AQA)
- 4.15 User management
- 4.16 Reset
- 4.17 Photometer information ([Info])
- 4.18 Lamp counter
- 4.19 Software and methods update
- 5 Maintenance and cleaning
- 6 What to do if ...
- 7 Technical data
- 8 Accessories and options
- Appendix
photoLab
®
6100 VIS Operation
147
ba75847e01 08/2009
Note
Make sure the folder structure of the files is retained while the files are
unpacked. If you use a program such as WinZip to unpack the files, the
option, "Nutze Ordnernamen" or "Use Folder Names" must be set. Details
are given in the documentation of the unpack program.
The "Update" folder must be on the top level of the USB memory device. The
Update folder contains several subfolders.
The following steps are carried out at the photometer.
Note
If the update cannot be carried out, an error message is displayed. Check
whether the "Update" folder with its subfolders is stored on the USB memory
device (top level).
3 Connect the USB memory device
to the photometer.
4 Switch on the photometer if
necessary.
5 Using <▲><▼>, select USB
memory as the source and press
<START·ENTER>.
The update process takes approx.
five minutes.
The photometer switches itself off
and then on again.
<HOME>
[General setup]
– Software/methods update
Software/methods update
04/16/07 9:52
Software/methods update
Select source of update data:
USB memory
PC
Cancel