User Manual

melt. Clean the tip by sliding the spring wire up and down until the passage is

clear. (See Fig. 3)

3.Unscrew the barrel nut assembly as in Figures 4 & 5.

FIG-4 FIG-5

4.Remove the tip by using a pliers as in Figures 6 & 7.

FIG-6 FIG-7

5.Insert the stainless tube of the tip back in the barrel to melt the solder in around 5

seconds as in Figure 8.

FIG-8 FIG-9

6.Remove again and shake out any loose melted solder in the tip per Figure 9, the tip

should now be unclogged. Replace the tip and screw back the retaining barrel nut

assembly but care should be taken not to over tighten!

PROCEDURES FOR CLEANING THE SOLDER COLLECTOR