User Manual
8
FUNCTION INTRODUCTION
Soldering /desoldering function introduction
(Both soldering and desoldering function can be set in the same way.)
TEMPERATURE SETTING: (No password set)
1. Increase temperature: By pressing “▲” key one time, the digital will be increase
“1” numeral. If pressing “▲” key over 2 seconds then the digital numerals will be
forwarded counting continuously till the temperature up to what you desire to set.
2. Decrease temperature: By pressing“▼” key, the same procedure as above.
PARAMETER SETTING:
1. Press “SET” key and hold for at least 5 seconds until display shows“— — —”
sign then release the “SET” key. The sign “— — —” starts to flash and
reminding the user to input the mode lock password “010” (fixed). If the user
inputs the same number as “010”, the unit will enter the modes selection
procedure, otherwise, the unit will be back from the current mode automatically.
2. After the unit enters the Modes selection, the LED will display “F-0”and flash.
Press “▲”or “▼” key to select modes. If the user doesn’t press “▲” or “▼” key
within 15 seconds or press “SET” key one time, then the unit will be
immediately back from the Parameter Set status.
For example: F-0 → F-1 → F-2 → F-3 →F-4
↑ ↓
← ← ← ← ←
3. Password Setting:
When the LED displays “F-1” and flashes, press “SET” key one time and the
unit enters the Password Set status. At this moment, the LED displays the pre-set
value. Press “▲” or “▼” key to change password set value. If the user sets
“000” that means the unit will be under the status of no password. If the user sets
“100” then means the unit will be under the password status. Press “SET” key
once to finish password setting and the unit will backup mode, the user can
continue set other modes or back from the setting mode.
4. Temperature Correction Setting
Press “SET” key once when the LED displays “F-2” and flashes that the unit
enters the Temperature Correction Mode. At this moment, the LED displays
preset correction value.
A: Operation of Centigrade temperature correction（Range +99℃~-99℃）
Press “▲” or “▼” key to change the temperature correction value.The first digit
“— ” in LED display means minus (actual temperature is down), “No display”
means plus (actual temperature is up).
B: Operation of Fahrenheit temperature correction（Range +178℉~-178℉）