User's Manual

P 8

234Filament is unloaded from

extruder automatically. Gently

pull filament out from the guide

hole when prompted.

When filament is pulled out,

press .

Remove cartridge locker

and the catridge.

Unload ﬁ lament

1 Select "Filament" > "Cartridge" > "Unload" on the screen

Please always complete the procedure for " Unload Filament " before changing a new cartridge.

Filament troubleshooting

When the filament is loaded automatically or is stuck in the extruder module, please first unload filament by

following the steps above. And then press on the black rubber fixers on either ends of the filament tube. You may

also follow the instructions on the screen for troubleshooting.

After removing the filament, plug

the filament tube directly back to

its original position to complete

the re-installation.

If the filament is stuck in the

extruder module, press the release

arm on the side of the extruder

module to extract the stuck

filament.

If the filament is stuck at the

entrance of the guide tube,

please press the release arm by

the entrance to extract the stuck

filament.

1 2

Status