User manual

P 7 HD23F1AS0C8

da Vinci 1.0 Pro 3in1

● UTILITIES > CLEAN NOZZLE

Printer Maintenance

Regular cleaning of the print nozzle facilitates to not only extending service life of the

printer, but also improves print quality.

Enable "CLEAN NOZZLE" (nozzle cleaning) function. Clean the nozzle after the nozzle

is heated up, the bed has been lowered and the extruder has been moved to the front

end, and "READY FOR CLEAN" is displayed on screen.

Clean the detecting pin with Copper Brush

Filament residues produced during printing may become attached to the nozzle and gear

of print module to influence print quality, operation of the printer, and measurement result

of the bed. If such a situation is encountered, please use a copper brush to clean the print

module by brushing off residue and dirt on the detecting pin .

Clean Nozzle with Nozzle Cleaning Wire

With increased print frequency, the carbon accumulation and dirt in the nozzle might affect

print quality. Thus, we recommend you to clean nozzle for every 25 hours of print. Please

clamp the nozzle cleaning wire with needle-nosed pliers to insert it into the opening of the

nozzle carefully for cleaning.

(Filament should be unloaded from the extruder before cleaning the feeding path.)

Wipe Measurement Points

After the bed is lowered, please switch off power to cool the bed, followed

by wiping 3 measurement points with damp cloth.

Before printing, stick the Bed Tape onto the print bed, followed by activating

print through one of the following “Other settings” ways:

* The Print Bed Tape is reusable. Replace the tape as it is worn out.

UTILITIES > JOG MODE > Z-AXIS

1. Select “010 mm” -> “[-], and then the platform will rise 10 mm

Select “010 mm” -> “[+], and then the platform will fall 10 mm

2.“Calibrate” it again, after nozzle is adjusted and all of the three measurement points can contact the probe.

● UTILITIES > BUILD SAMPLE

Print Built-In Sample

Adjust the distance between nozzle and platform

When the probe cannot contact any measurement point, Z-Axis

can be used to adjust an appropriate distance

Select the sample to be printed from built-in samples, followed by pressing "OK" key

to start print.

Functional operations and descriptions

JOG MODE

X-AXIS

Y-AXIS

Z-AXIS