User manual

P 13 V.1
da Vinci 1.0 Pro
Install and Load Filament
UTILITIES > CHANGE CART > LOAD FILAMENT
● Install Filament Cartridge
from XYZprinting
● Install Compatible filament
● If select XYZprinting filament and setting
preference, select "YES"
● If setting preference by manually, select "NO"
CHANGE CARTRIDGE
>LOAD FILAMENT
USE XYZPRINTING
CARTRIDGE NOW?
> YES
USE XYZPRINTING
CARTRIDGE NOW?
> NO
◆ Remove the filament stopper and tape
and install the filament cartridge into the
empty slot
◆ Place and push to click the
cartridge
◆ Please erect filament spool by
yourself 。
Wait for the extruder to heat up
As the temperature reaches operating
setting the printer loads automatically
the filament, and filament loading is
completed
Check if filament flows out from
the nozzle. If the filament has
flowed out, please press “OK”
◆ Insert filament into the guide hole until the printer starts to load filament.
◆ Press the release arm to facilitate replacement and installation of filament
◆ Then, activate LOAD FILAMENT function on the printer
Activate LOAD FILAMENT function
on the control panel
Filament loading is completed
After selecting "USER FILAMENT"
and pressing "OK" key, the operating
temperatures for heating up procedures
may be set, respectively. After adjusting
to appropriate temperatures,return to
the previous page and select "APPLY
SETTING" to save settings, such that
customized temperatures may be
applied
The temperature setting in this procedure is applicable
only to 3D Builder application software developed by
Microsoft. For more information about 3D Builder, please
visit the Microsoft website
A.
B.
C.
Remarks:
Operation for Functions
◆ If you use your own filament, please make
sure no cart in the tray or remove the cart
if any
Note : Before pushing the filament into the guide hole, please cut the tip of the filament off at a 45°