User manual

P 22 V.1
da Vinci 1.0 Pro
Error Status Recommended Process Ways
Printer is busy
Firmware of the printer
cannot be updated
Filament is clogged
Filament cannot be loaded
NO CARTRIDGE
Filament is not installed correctly
CARTRIDGE EMPTY
There is no residual filament prior to print: remain 0%
FILAMENT LOW
Filament residual is low: remain 30%
FILAMENT END
There is not filament residual in printing: remain 0%
Try again after current task is completed, and examine the information
displayed on screen of the printer
Check internet connection / Update firmware later
Unload filament and reload it, and clean nozzle, too
Unload the filament and reload it
Reload or replace the filament
Replace filament immediately
Replace filament as need
Replace filament immediately
Support Information
Maintenance and Service
Federal Communications Commission (FCC) Statement
If the printer is delivered for repair during warranty period, it is recommended to pack the machine with original packing materials
before transportation. Therefore, please keep original packing materials. If other packing materials are used instead, the print er may be
damaged during print process. In such situation, the XYZprinting the right to charge repair fee.
You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority
to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
● Consult the dealer or an experienced radio/TV technician for help.
XYZprinting is not responsible for any radio or television interference caused by using other than recommended cables and connectors or by
unauthorized changes or modifications to this equipment. Unauthorized changes or modifications could void the user's authority to operate the
equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This device complies with FCC radiation exposure limits set forth for an uncontrolled environment and it also complies with Part 15 of the FCC
RF Rules. This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used for this transmitter
must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with
any other antenna or transmitter. End-users and installers must be provided with antenna installation instructions and consider removing the no-
collocation statement.