User manual

P 3 V.1

da Vinci 1.0

Pro

Replace the laser engraving module:

Installing the laser engraving module:

Dismantling the laser engraver module

●

Introducing the installation / detachment of the laser engraving module

Before replacing the extruder module with the laser engraving module, check if there are remaining ﬁ laments in

the nozzle and remove them accordingly.

After removing the ﬁ lament,

please select [CHANGE NOZZLE].

Wait for the panel to display the

message that allows you to switch

off the power to replace the

printing module before switching

off the power.

Unplug the heating bus at the side of the extruder module

Move the module manually to the center or

any other position that allows easy detach-

ment of the module.

Move the module manually to the center position.

Install the buses, and pay special attention to the upper and lower buses.

Pull the quick-detachment button. Tilt the laser engraving

module and insert it into the installation slot.

Press the quick-detachment button and ensure that the

module is secured by the locking lever at the correct

position to complete the installation.

Pull open the quick-detachment lock to release the extruder mod-

ule. Tilt the module and remove it from the slot. Provide proper

safekeeping of the extruder.

(avoid touching high temperature extruders to avoid burns)

UTILITIES

CALIBRATE

BUILD SAMPLE

CHANGE NOZZLE

TURN OFF POWER

AND THEN CHANGE

NOZZLE MODULE

◆

Switch off the printer power.

Pull the quick-detachment button. Tilt the laser engraver mod-

ule and take it out from the installation slot.

Detach the connected cables.

Complete dismantling and provide proper safekeeping of the

laser engraver module.