Quick Start Guide
May 2016
P 6HD23F1JP0E8
da Vinci
Jr.1.0 Pro
First retrieve lament spool to install the lament
spool axle ring.
Place the assembled lament spool (with the spool axle
rings) on the lament holder on the left side of the printer.
Pull out a section of the lament and insert it into
the feed port.
Caution: Pay attention to the direction the
lament is being pulled out and ensure that
the lament spool axle is being rotated in the
correct manner.
Open the release arm and push the lament all the way
to the bottom so that the front end of the lament is
completely inserted into the feed module.
Take out and separate the lament spool axle
ring into its two components.
Install the sensor chip. Please pay special attention to
the position of the installation holes on the chip.
Insert the lament spool axle ring components
to either side of the lament spool, and use a
cruciform screwdriver to tighten and secure the
rings to the axle to complete the installation of
the lament spool axle rings.
1
2
3
4
5
6
7
Load Filament
CHANGE SPOOL
Note : Before pushing the lament into the
guide hole, please cut the tip of the lament
off at a 45°