User's Manual

Ver.1 March 2015
P 6
da Vinci Jr.1.0
First retrieve fi lament spool to install the fi lament
spool axle ring.
Place the assembled fi lament spool (with the spool axle
rings) on the fi lament holder on the left side of the printer.
Pull out a section of the fi lament and insert it into the
feed port.
Caution: Pay attention to the direction the
fi lament is being pulled out and ensure that the
fi lament spool axle is being rotated in the correct
manner.
Open the release arm and push the fi lament all the way
to the bottom so that the front end of the fi lament is
completely inserted into the feed module.
Take out and separate the fi lament spool
axle ring into its two components.
Install the sensor chip. Please pay special attention to
position of the installation holes on the chip.
Insert the fi lament spool axle ring components
to either side of the fi lament spool, and use a
cruciform screwdriver to tighten and secure the
rings to the axle to complete the installation of
the fi lament spool axle rings.
1
2
3
4
5
6
7
Load Filament
CHANGE SPOOL