User Manual

V1
-3-
⑦Shake the resin bottle for around
10 seconds to ensure even color.
⑧Assemble the nozzle cap and the
tube (placed in the rinse basket when
shipped).
⑨Replace the bottle cap with the
assembled nozzle cap.
Unpacking & Setup
After removing all external packing
materials and tapes…
①Take off the lid and remove the
accessory tray over the platform.
③Connect power adapter, power cord
to the printer. Switch on the printer.
(Please do not use the power adapter
for Nobel 1.0 on this model.)
②Lay down the printer, and release
the printing module locker by pushing
it to the right. Follow the procedures
to remove the protecting foam under
the platform.
④Raise the platform:
On the printer screen, select
“UTILITIES” and press ► to find
“MOVE PLATFORM”>”TO TOP”.
And press “YES” to raise the
platform.
⑤When the platform is moved to the
top, remove the protecting foam.
⑥Unpack the resin tank and insert it
into the tank slot. Push all the way
until reaching the end.
⑩Install filling tubes.
Push the tubes all the way down.
First attach the black tube to thick
nozzle, and then connect the
transparent tube to thin nozzle.
Put on the lid, and it’s ready for
printing.
(Bottom of the printer)