User's Manual

Troubleshooting
Be sure to wear gloves for the operation!
You may also brush out the uncured resin in the alcohol.
When an error occurs, please refer to the service code on the printer and/or in the software, and check the suggestion below for
troubleshooting.
If any error persists, please contact customer service center for support.
Note
③ Rinse part in Alcohol (≧75% Alcohol)
Pour alcohol into the rinse basket, shake the print for 10
minutes and rub it with fingers thoughroughly.
Remove any residue in the resin tank. Operate gently to
avoid scratching the surface of the resin tank. Reinstall the
resin tank after cleaning.
Scrap off any residue and remove excess resin from the
surface of the platform. When reinstall it to the printer, turn
the platform locker clockwise until it stops.
④ Cleanup and reinstall
● Error Code 1000: Vibration generator movement abnormalities or tank sensormalfunctioned
Suggestion:
Contact customer service center directly.
V1
-10-
Post-Process Your Prints
Remove Support Structure
Use pliers or other tools to remove the support structure
from the cleaned prints to ensure perfect finish.
Empty Uncured Resin Inside the Prints
Hollow prints with uncured resin inside may break as time
passes. To ensure the durability of hollow prints, leave a
weep hole at the bottom of your 3D design, so you can
empty the uncured resin easily.