User's Manual

LCM Menus
UTILITIES
FILL RESIN TANK
V1
-5-
“Utilities” menu provides the control of the printer. You can instruct to fill the resin tank manually, calibrate the
printer when necessary, and print the built-in samples.
You can activate resin-filling function manually. Before doing so, make sure the resin cartridge, resin tank and the lid
are installed correctly. (See “Unpack & Setup” for details).
“Horizon Calibration” ensures the platform is parallel with the resin tank for more stable printing performance.
Always perform “Horizon Calibration” after changing to a new tank or a tank different the one used for last print.
Select “Yes” and press [OK] to begin:
• If “Auto Fill” function under “Settings” menu is disabled, be sure to load resin manually before printing.
• Shake the resin cartridge well before use ensures even color.
HORIZON CALIB
INSTALL RESIN
BOTTLE BY NOW
NO
►YES
MAKE SURE BOTH
PIPE HAS BEEN
INSTALL PROPERLY
[OK] FOR NEXT
RESIN TANK IS
FILLING UP NOW
PLEASE WAIT…
MOVE PLATFORM
Activate the function when you need to move the platform manually.
Simple select move the platform “to top” or “to bottom” to proceed:
PRINT SAMPLE
MOVE PLATFORM
TO TOP
►TO BOTTOM
Select “Yes” and press [OK] to begin:
Note
3 sample models are built-in the printer. You may begin your first 3D prints with the samples.
Simply select one of the sample to begin:
See “Printed Object Removal and Cleaning” for post-print steps.
PRINT SAMPLE
►PRINT SAMPLE01
PRINT SAMPLE02
PRINT SAMPLE03
START PRINTING?
SAMPLE FILE
NO
►YES
Note
To ensure the accurracy of calibration, please empty
the resin tank before calibrating.
Note
START HORIZONAL
CALIBRATION NOW?
NO
►YES
MOVE PLATFORM
TO BOTTOM NOW?
NO
►YES
REMOVE OBJECT
FROM PLATFORM
[OK] TO CONTINUE
①②③
④
Tighten the screws
diagonally across the
print bed locker to
make sure the force is
even.
TIGHTEN ALL 4
SCREWS ABOVE
THE PRINT BED
[OK] TO FINISH
LOOSEN 4 SMALL
SCREWS ABOVE
THE PRINT BED
[OK] TO CONTINUE