User's Manual

SETTINGS
BUZZER
V1
-6-
The Settings menu alows you to adjust printer settings.
When the buzzer is turned on, the printer will output an audible signal when a button is pressed, print job is finished,
or issue is detected.
When “Auto Fill” is enabled, the printer will fill the resin tank before printing and when low tank level is detected.
With auto fill function, you are free from manual resin filling during printing. This is especially useful when printing
large objects.
Buzzer is turned on by default. To switch off the buzzer:
Select “OFF” and press [OK] to change the setting.
AUTO FILL
BUZZER [ON]
►OFF
ON
ENERGY SAVE
LED backlight of the LCM enhances the readibility of the content of the display. To save energy consumed, the
backlight will go off after the printer idles 3 minutes (shown as 03M on the display) by default.
“Auto Fill” is enabled by default. To disable the function:
Select “OFF” and press [OK] to change the setting.
Be sure to place the printer on a leveled surface, or tank level detection may be inaccurate.
Note
To set a longer time interval:
Select an option, and press [OK] to change the setting.
Backlight will never go off.
Backlight will go off after the printer idles 3 minutes.
Backlight will go off after the printer idles 6 minutes.
RESTORE DEFAULT
All settings can be reset to factory default with a few clicks.
To reset all settings at once:
RESTORE DEFAULT
ARE YOU SURE?
NO
►YES
Simply select “YES” and press [OK] to reset.
ENERGY SAVE [OFF]
►OFF
03M
06M
AUTO FILL [ON]
►OFF
ON