User manual

Components
Power Cord
UV Curing Chamber
Power Adapter
Quick Guide
(This sheet)
Warranty card
XYZprinting UV Curing Chamber User Manual
ENGLISH
The UV Curing Chamber is a component of 3D printing solutions. The UV device outputs steady, focused and consistent UV lights to cure the
printouts printed with photopolymer resins in a short period. The post curing process increases the hardness and durability of the printed
products.
After removing all packing materials, open the cover door and
peel off the transparent protection films from the reflective
sheets.
Safety / Operation Notices
LED Indicator
The LED lights indicate the status of the curing
chamber. To switch setup item, press [MODE] button.
▪ The glass cover over the UV LED diodes gets warm after
curing. Please avoid touching the glass cover.
▪ Objects feel warm right after being cured. The heat from
the UV unit does not affect the quality of the objects.
▪ The product is used to cured the objects printed with
photopolymer resin. Please do not cure other items.
▪ Use only the power cord and the power adapter that come
with this product. Use of another cord or power adapter
may result in the malfunction of the product or cause injury
to the user.
▪ The product is designed with safety in mind. Curing stops
automatically when the cover door is opened. Please do
not disassamble the product, or the safety protection may
be impaired. This may cause injury to eyes caused by UV
exposure. This will also void warranty.
▪ The device is intended to be used in office, not for home
use.
Unpacking Package Contents
POWER
TIME
CURING
Lit when switched to curing power level setup.
To adjust power intensity, press [+] or [-].
Intensity 01
Intensity 02
Intensity 03
Lit when switched to curing timer setup.
Curing timer with range from 1 to 60 minutes.
Adjust by 1 minute intervals, click [+] or [-].
Adjust by 5 minute intervals, press and hold [+] or [-].
Both LED lit when in turntable setup mode.
To setup the turntable, press [+] or [-].
Setting 00 - Turntable disabled
(The setting allows you to cure in silence. If the
object is too large to fit in the turntable, you may
also disable the turntable.)
Setting 01 - Turntable enabled
(The setting provides better curing efficiency.)
Lit when curing is in progress. The LED blinks when
curing is paused (as happens when the cover door is
opened).
POWER
TIME
[Front view]
DC IN Terminal
Air vent*
UV LED Diodes
Turtable
Reflective sheet
[Back view]
[Interior]
Increases / decreases power level,
curing timer, or enables / disables the
turntable.
Starts curing. Curing is stopped
after this button is pressed
during curing.
Click to switch to power level, curing
timer or turntable setup.
Power button: click to
power on the device,
press and hold to power
off.
Operation panel
POWER
TIME
CURING
Display for power level, curing timer or turntable setup.
When curing is in progress, the display switches to a countdown timer.
* Do not block the air
vent during curing.
POWER / TIMEON / OFF
START
STOP
MODE
60
*Please retain all original packaging material that came with the product. If warranty
service is needed, please ship your product with the original packaging. Shipping without
the original packaging material may cause product damage during the shipment and
may result in additional service fees for which you shall
be solely responsible.
-1-