User manual

How to UV Cure
Maintenance
Product Specs
①Insert the power cord into the power adapter
and plug the other end into the power outlet.
②Connect the power adapter to the curing
chamber’s DC IN terminal at the back.
Click on the [Power Button] to
power on the device.
Open the cover door, put the UV resin-printed
object on the turntable, and close the door.
Ensure the cleanness of the resin-printed objects.
▪ Wash the printed objects thoroughly in alcohol.
▪ Leave the printed items until alcohol on the surface
evaporates.
②Click to adjust power level or
curing time or enable/disable
the turntable.
Set up curing power intensity, timer and the turntable
based on the features of the printed object.
①Click to switch setup mode.
③Click to start curing.
Connect the curing chamber to the power source.
Ensure the cleanness of the relective sheets and
the glass cover over the UV LED diodes.
▪ Use lint-free cloth dampened with alcohol to
wipe any resin or alcohol off the components
before it gets cured.
Curing Guidelines
①
②
Model number
Light source
Max. curing size
Turntable payload
UV LED lamp power
Power supply
Operating conditions
3UD10
UV LED λ 385 nm
Ø180 x H200 mm
1.5 kg
16 Watt
DC IN 24V 2.5A
Temperature: 10-35℃/50-95℉
Humidity: 40-80% RH (no condensation)
MODE
POWER
TIME
START
STOP
*Curing stand is to be prepared by yourself.
You may use any object as the stand or download the 3D model from
XYZprinting 3D gallery by going to http://us.gallery.xyzprinting.com/ and
select “SLA Accessories” from the categories. Download the 3D models of
the curing stand and print them out.
Note
*For the curing instrucions for XYZprinting functional resins, please refer to
the product pages on XYZprinting website.
To achieve highest curing efficiency:
▪ Put the object at the center of the turntable.
▪ Make sure that as much of the object as possible
is facing the LED diodes at the top.
▪ For large object, you may tilt it on the curing stand.
▪ Lift small objects with the stand to close to the UV
LED diodes.
▪ Turn the object over periodly to get fully cured.
Curing is paused when the cover door is opened. So you can
adjust the placement of the object anytime. Simply close the
cover door to resume curing.
▪ Object printed with clear and white resin may
begin yellowing after cured.
▪ Over-curing the resin prints will cause excessive
yellowing.
▪ Be sure to rotate the object and start over the
curing process to ensure the object is fully cured.
Recommended curing setup for XYZprinting resins:
Curing efficiency:
Better Fair
● UV LED diodes
● Curing stand*
XYZprinting Resin
General purpose resins
(Grey/Clear/White/Blue/Magenta)
Power Intensity
03
Cure Time
10 minutes
-2-