User's Manual

-17-
For models with non-manifold geometry (black-highlighted in the software), please repair the models before printing.
●Support:
For models of top-heavy structure, with overhanging parts or with less contact with the platform after rotated, please add support structures.
For larger overhanging parts, please choose the support structure with higher density and larger contact point.
Tips
Optimize the placement and the support structure of the model with the ”Rotate”, “Support” and “Brim” functions in the software.
●Rotate:
For models of top-heavy structure, with less contact with the platform, or with any larger solid layer, please rotate the model to reduce the effect of peeling force during build
process.
●Brim:
One of the keys to successful printing on the bottom up type SL printer is to ensure the adhesion of the model to the platform. If rotating the model doesn’t increase the
contact between the models and the platform greatly, please check “Brim” while exporting or printing the file. Also add “support” if necessary.
B. Also make sure that the printer and the printout setting is optimized by following the tips below.
Support
Brim